9. Measuring using Measuring-Menus
9.3 Measuring point scans and Output
Measuring point scans can be used to acquire
the measured values of all measuring points at
particular times, either manually or cyclically
over a period of time, which means to store or
to record on printer or computer (s. man. 6.5).
For this purpose, the menu
Data logger
, e.g.,
is available:
9.3.1 Single Output / Storage of all Measuring Points
Single manual measuring point scans for acquiring the momentary measured
values of all active measuring points
(s.man. 6.5.1.1)
can be triggered by the key
<MANU>
. If the true time of day has to be indicated, it must first be set (s.
10.1.1). The output format can be set in the function
Cycle Timer
(s. 9.3.2).
Single manual measuring point scan:
<MANU>
The following symbols will,
for a short period,
be indicated in the
status line
:
The start arrow will light up and then go off again
´
©
´
Lightening up in case of data output via interface
´
COM
´
Indicated when measured values are being stored (s. 10.1.2)
´
REC
´
Each time the key is pressed again after this, the measured values are equally
processed with the corresponding measuring time.
9.3.2 Cyclic Output / Storage of all Measuring Points
For cyclic outputs of measured values (s. man. 6.5.1.2) and recording, the cy-
cle and the output format have to be programmed. The measurement can be
started
by pressing the key
<START>
and
stopped
with the key
<STOP>
. At
each start of a measurement the max, min and average values of all measu-
ring points are cleared, if the device has been correspondingly configured
(standard setting, s. 10.5.8).
The function
Cycle Timer
indicates the cycle as long as a measurement has
not been started. After selecting the function (s. 8.4), the cycle can be entered
immediately (s. 8.5). After starting a measurement you can see the timer coun-
ting down to the next cycle.
Function
Cycle Timer
:
Cycle Timer:
00:02:00
S
Cycle (
hh:mm:ss
), Memory On, Format List
28 ALMEMO 2690-8
C © REC COM l© ©l R01 * ´´´´´´µµµµ¶
±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±
Time: 12:34:56 Date: 01.01.04
Cycle timer:
00:00:30 nS
Memory free:
508.3 kB
Number:
01-001 A
01: 244.5 °C
NiCr Temperatur » H º
7 Limit max:
250.0 °C
Maximum value:
245.7 °C
7 Limit min:
230.0 °C
Minimum value:
224.1 °C
START MANU M PRINT ESC
