- 2 –
1
How to activate or deactivate the
Transparent Mode
1.1
How to control the Transparent Mode via the status
display
In the Transparent Mode you can directly communicate with the
measuring circuit boards via the ALMEMO
®
Control program.
In the Transparent Mode there will be no data logging performed via
the web service and the app. In the Transparent Mode there will be
no measured values displayed in the app.
Activate the Transparent Mode
!
The data logger needs to be switched on.
!
The data logger needs to be connected to the power supply (see Instruction
Manual chapter 7.1.1 How to connect and check the Power Supply).
In battery operation (no mains adapter connected) the Transparent
Mode cannot be activated. In case a battery pack is used in your
system for the time of activated Transparent Mode the datalogger
must be connected to the power supply.
The data logger is ready for use as
soon as the menu “1) Network
Conf.” in the status display shows
an IP address (see example on the
right).
1.
Keep pressing the right one of the
navigation keys (directly
underneath the status display) until
the status display shows the menu
“4) System”.
1) Network Conf.
IP-Address
192.168.11.106
Subnet-Mask :
255.255.255.0
4) System:
Temp: 44°C
Load: 21%