S150/S151/S152/Z152
1-7
Safety regulations
1
2
1
1.5.1.34
During work-brakes and after work hours the
driver should endeavor to leave the machine on good
bearing soil and if possible on level ground and safeguard
the machine to prevent it from unintentionally rolling away.
1.5.2
Special work within the exploitation
of the machine and elimination of defects
during process or work; disposal
1.5.2.1
The prescribed dates for adjustment work, mainte-
nance work and inspections laid down in the operating
manual (machine and engine) must be strictly observed.
This also applies to details regarding the interchanging of
parts/ part equipment. This work may only be executed by
skilled personnel.
1.5.2.2
For all work concerning the operation, conversion
or adjustment of the machine and its safety devices as well
as inspection, maintenance and repair work please observe
the switching and stopping operation in accordance with
the operating manual (machine and engine) as well as the
related instructions for maintenance work.
1.5.2.3
The engine must be switched off before mainte-
nance or repair work is carried out.
1.5.2.4
The stability of the machine or the attachments
must be guaranteed at all times during maintenance and
repair work.
1.5.2.5
Maintenance and repair work may only be carried
out when the attachment is set down on the ground or
supported or when equivalent measures against un-
intentional movement were taken.
During maintenance and repair work under the bucket arm:
- the bucket arm must be mechanically propped up,
e.g. by inserting the bucket arm support (option) (1-1/
arrow).
- the hand levers for the hydraulic loader (1-2/1) and
auxiliary functions (1-2/2) must be secured.
- the swing mechanism must be blocked. Remove the
blocking wedge (1-3/arrow) out of the mounting, switch to
swing blocking (1-4/arrow), and secure with spring pin.
1.5.2.6
If necessary, protect the maintenance area on a
large scale.
1.5.2.7
The machine must be protected from un-
intentionally starting after it was switched off for mainte-
nance and repair work:
- remove the ignition key
- attach warning sign at battery main switch.
This applies especially to works to the electrical equipment.
1.5.2.8
Individual pieces and large assemblies must be
carefully secured to hoisting equipment when being
substituted to avoid any damage. Only suitable and
technical sound hoisting equipment may be used as well
as crane equipment with adequate payload. Do not stand
or work underneath suspended loads!
Figure 1-1
Figure 1-3
Figure 1-2
Summary of Contents for AS 150
