OEM/Integrators Installation Manual
Important Notice to OEM integrators
1.
This module is limited to OEM installation ONLY.
2.
This module is limited to installation in mobile or fixed applications, according to Part
2.1091(b).
3.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4.
. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to
verify compliance as a composite system. When testing the host device for compliance with
Part 15 Subpart B, the host manufacturer is required to show compliance with Part 15
Subpart B while the transmitter module(s) are installed and operating. The modules should
be transmitting and the evaluation should confirm that the module's intentional emissions
are compliant (i.e. fundamental and out of band emissions). The host manufacturer must
verify that there are no additional unintentional emissions other than what is permitted in
Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s). The Grantee will
provide guidance to the host manufacturer for Part 15 B requirements if needed.
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible through a
window on the final device or it must be visible when an access panel, door or cover is easily
re-moved. If not, a second label must be placed on the outside of the final device that contains
the following text: “Contains FCC ID: 2ATPO-A9G ”
The FCC ID can be used only when all FCC compliance requirements are met.
In the event that these conditions cannot be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC/IC authorization is no longer considered valid
and the FCC ID/IC ID cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC/IC authorization.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warning as show
in this manual.
