J4076-01 User's Manual
35
Chapter 3 Sub-System configuration Setup
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >standby_timer 10
Succeeded to set standby timer
cmd >reset_
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >standby_timer
Standby Timer : 0 minutes
cmd >_
3.5.6 How to configure standby timer for all disk drives(EDGE only)
This feature is applicable for SAS/SATA drives. Standby timer is in units of
minutes. Setting standby timer with 0 minute disables this feature.
(A) Get current standby timer
cmd> standby_timer
Standby Timer : 0 minutes
(B) Set the standby timer with 10 minutes. The new setting will take effect
after reset.
cmd> standby_timer 10
cmd> reset
WARNING : This function is not recommended to use with
RAID card since RAID card limitation.
