J4076-01 User's Manual
43
Chapter 3 Sub-System configuration Setup
3.5.12 How to configure zone count
Remove the SAS cable between the HBA/RAID card and the 4U76-01
before configuring zone count. Power the 4U76-01 off after configuring
zone count. Power on the 4U76-01, and then insert the SAS cable.
Three zone configurations supported are one zone, two zones, and
four zones. The default configuration is one zone of which T10 zoning
configuration is disabled. T10 zoning configuration of the other
configurations (two zones and four zones) is enabled. All COM ports
for HUB and EDGE should be applied with the same configuration.
Port connection, refer to
1.4 8644
with Zoning Configuration and
8644
port definition
(A)Get current zone count
cmd> zonecount
Zone Count 1
(B) Set zone count = 2
cmd> zonecount 2
Succeeded to set zone count 2
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >zonecount
Zone Count 1
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >
cmd >zonecount 2
Succeeded to set zone count 2
cmd>_
