1
Chapter 1� Product Features
RMC-1E is a space saving rackmount management chassis with tool-less design. This
product supports hot swappable HDDs and easy swap fans. For more information about
our product, please visit our website at
http://www.aicipc.com/en/index
.
Before removing the subsystem from the shipping carton, visually inspect the physical
condition of the shipping carton. Exterior damage to the shipping carton may indicate that
the contents of the carton are damaged. If any damage is found, do not remove the com-
ponents; contact the dealer where the subsystem was purchased for further instructions.
Before continuing, first unpack the subsystem and verify that the number of components
in the shipping carton is accurate and in good condition.
1�1 Components
This product contains the components listed below. Please confirm the number and the
condition of the components before installation.
• Chassis (includes power supply, fan & hard disk drive cage)
• Power cord (vary per region)
• Slide rail x 1 set (optional)
Pre-installed into the system
Number
250W single power supply unit
1
3.5-inch internal hot swap cage
2
40x28mm fan
3
Accessory Item
Number
EPE foam for top: 555*525*47H
1
EPE foam for bottom: 555*525*87H
1
PE bag: 56(O/W)*70CM,T=0.1MM
1
Power cord
vary per region
BTO
20-inch tool-less slide rail assembly
1
300W redundant power supply unit
1+1
Product specifications and features are subject to change without prior notice�
