AIC RSC-2ET, User Manual

•  Ensure that the voltage of the power source is within the specification on the label 

when connecting the equipment to the power outlet. The current load and output power 

of loads must be within the specification.

•  This equipment must be firmly connected to reliable grounding before usage. Pay 

special attention to power supplied other than direct connections, e.g. using of power 

strips.

•  Place the power cord out of the way of foot traffic. Do not place anything over the 

power cord. The power cord must be rated for the product, voltage and current marked 

on the product’s electrical ratings label. The voltage and current rating of the cord 

should be greater than the voltage and current rating marked on the product.

Pay attention to hardware maintenance.

Pay attention to hardware maintenance.

注意硬體維護

注意硬體維護。

。

注意硬体维护

注意硬体维护。

。

Обратите внимание на обслуживание оборудования.

Обратите внимание на обслуживание оборудования.

Besteed aandacht aan hardware-onderhoud.

Besteed aandacht aan hardware-onderhoud.
•  If the equipment is not used for a long time, disconnect the equipment from mains to 

avoid being damaged by transient over-voltage.

•  Module and drive bays must not be empty. They must have a dummy cover.

•  Never open the equipment without professional assistence. For safety reasons, only 

qualified service personnel should open the equipment.

•  If one of the following situations arise, the equipment should be checked and tested by 

service personnel:

1.  The power cord or plug is damaged.

2.  Liquid has penetrated the equipment.

3.  The equipment has been exposed to moisture.

4.  The equipment does not work well or will not work according to its user manual.

5.  The equipment has been dropped and/or damaged.

6.  The equipment has obvious signs of breakage.

7.  Please disconnect this equipment from the AC outlet before cleaning. Do not 

use liquid or detergent for cleaning. The use of a moisture sheet or cloth is 

recommended for cleaning.

CAUTION

The equipment intended for installation should be placed in Restricted Access Location.

CAUTION

There will be a risk of explosion if battery is replaced by an incorrect type. Dispose 

of used batteries according to the instructions. After performing any installation or 

servicing, make sure the enclosure is correct in position before turning on the power.

CAUTION

This unit may have more than one power supply. Disconnect all power sources before 

maintenance to avoid electric shock.

iii