6
Seating
The comfortable seat cushion allows you to be
seated for a long period of time. The cushion is
held in place by Velcro and can also be
removed. The cover can be washed
(see the instructions on the cushion).
Seat Depth Adjustment
After loosening the screws
(1)
underneath the seat pan,
(with an allen key) the seat depth can be set to
the desired position.
Then tighten the screws again.
CAUTION! A A
The maximum seat depth (see marking and
end stop) must not be exceeded.
Seat width adjustment (7.105.1)
You can extend the width of the seat of your
wheelchair by removing the upholstery
(A).
Adjustable seat angle (2°-20°)
By pulling the right hand lever while pushing down
on the silver cross bar the seat can be tilted into the
desired position. When you let go, the seat is
automatically fixed in the new position.
By pulling the left hand lever, only the backrest can be
reclined to the desired position. When you let go,
the back will automatically be fixed in the new position.
Please Note:
Having the back reclined without first tilting the seat
may cause the occupant to slide out of the wheelchair.
CAUTION:
The angle-adjustable seat may only be used with anti-tip tubes. The gap between the anti-tip tubes and the
ground must be a maximum of 2.5 cm.
CAUTION:
To ensure the correct function of the cables, these must never be taut.
CAUTION:
There is a danger of trapping your fingers when you adjusting the seat.
CAUTION:
Never adjust the seat angle if the wheelchair is on a slope.
