Usage and Maintenance Instructions
Ver. 3 07/2012 (1707)
2
INTRODUCTION
Thank you for deciding to purchase the Plate Guard from Aidapt. The Plate Guard is
manufactured from the finest materials and components available. When used
correctly it is designed to give many years of reliable trouble-free service.
VM904
Size: 203 - 304 mm (8 - 12")
VM905
Size: 216 - 254 mm (8.5 - 10")
VM906
Size: 254 - 280 mm (10 - 11")
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.
INSTRUCTIONS FOR USE
Using the Plate Guard is simple:
•
Place the Plate Guard onto a dining plate with the plate clips positioned
below the edge of the plate.
•
The Plate Guard is flexible and can accommodate a range of plates
depending on the in diameter (please check the table above for the size
range of the Plate Guard you have purchased).
•
The plate clips will hold the Plate Guard in place when in use.
•
The Plate Guard can then be used to push food onto a fork or spoon, using
only one hand, while also preventing spillage.
CLEANING
Clean your Scoop Plate using a non-abrasive cleaner or mild detergent with a soft
cloth. Abrasive cleaners e.g. AJAX and/ or abrasive cleaning pads may damage the
product beyond repair and should not be used. Always ensure that you rinse then
wipe dry the equipment after cleaning.
The Scoop Plate can also be cleaned on the top tray of a domestic dishwasher on a
standard/eco or cool program.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
If in any doubt, please do not issue or use, but immediately contact your
supplier for service support.
