Usage and Maintenance Instructions
Ver. 1 01/2013 (2546)
3
PERMANENT INSTALLATION OF RAMP
Figure 1
Figure 2
Figure 3
1. Clean and dry the substrate.
2. Dry fit the ramp by placing it flush against the threshold.
3.
Cut notches into the ramp as necessary to fit (Figure 4).
WARNING: Do not use a power circular saw to cut ramp product.
4.
Use Painter’s tape to outline the rap (Figure 1).
5. Remove the ramp (Figure 2).
6. Using a caulking gun, generously apply adhesive onto the substrate near the
tape (Figure 3).
7. Apply pressu
re to the ‘toe edge’ and squeeze the adhesive out onto the tape.
8. Place heavy objects(i.e. sandbags) on the ramp overnight.
9. When adhesive is dry, cut off any excess adhesive with a utility knife.
10. Remove tape (Figure 5).
Figure 4
Figure 5
