Usage and Maintenance Instructions
Ver. 2 08/2012 (2239)
3
ASSEMBLY PROCEDURE
1.
Fix the main supporting tubes with screw (B) (8) and washer (10), washer (9) and
nut (11).
2.
Lay the seat upside down and put the main supporting tub in the slot of the bath
seat as per the diagram.
3.
Fix the back support/main support and bench seat with screw (C) (7) and washer
(10).
4.
Assemble the seat and back support with screw (A) (6) and washer (10).
5.
Make sure all screws are fully tightened before use.
NB. We do not recommend the use of a battery operated screw driver when assembling
this product.
ASSEMBLY DIAGRAM
HEIGHT ADJUSTMENT
1.
Depress the securing pin and twist the extension leg to the side to allow you to
slide the extension leg up or down to the desired height.
2.
Rotate the leg back to allow the securing pin to pop out of the hole and fix the
height at the correct setting.
3.
Repeat steps 2.1 and 2.2 above for each leg, ensuring that all four legs are set to the
same height setting.
