Usage and Maintenance Instructions
Ver. 2 08/2012 (2162)
2
INTRODUCTION
Thank you for deciding to purchase the Plastic Handled Button Hook from Aidapt.
The Plastic Handled Button Hook is manufactured from the finest materials
available. When used correctly it is designed to give many years of reliable, trouble-
free service.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.
INTENDED USE
This is an invaluable item for people who have difficulty fastening buttons. The
Plastic Handle Button Hook is ideal for people who only have the use of one hand,
or limited dexterity.
INSTRUCTIONS FOR USE
•
Grip the plastic handle with the hand on the same side as the button hole
•
Pass the stainless steel loop through the button hole towards the button
•
Position the widest part of the steel loop over the button and move it to
the side so that the narrow point of the steel loop is directly below the
button, around the securing thread
•
Pull the plastic handle back so that the steel loop passes back through the
button hole, with the button still in the steel loop
•
Gently push the steel loop forward so that the widest part of the loop is
below the button and then lift it up and over, leaving the button in the
button hole.
