Fixing and Maintenance Instructions
5
CLEANING
A useful guide to decontamination is MHRA leaflet DB2003(06).
Do not use abrasive cleaners as this could damage the surface of the equipment. For cleaning,
wipe with a clean cloth soaked in detergent solution and wring out. Depending on the detergent
manufacturer’s instructions the solution may be heated.
Wipe all surfaces of the equipment and the cloth should be re-immersed periodically and the detergent
changed frequently. The detergent should be rinsed or wiped off using a clean cloth immersed in clean
water and wrung out.
To disinfect make sure the equipment has been cleaned and dried and then wipe over with a clean
cloth and a compatible liquid disinfectant. After disinfecting clean with clean water and dry.
When using detergent or disinfectants then please refer to manufacturers’ instructions and if unsure
then consult your local Infection Control Specialist for advice.
This equipment can be cleaned/disinfected by moist heat at 80ºC for a minimum of 1 minute or
autoclaved at 80ºC for at least 1 minute. After cleaning or disinfecting dry and treat all joints with a
water dispersing agent, e.g. WD40.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components for their
safety.
This includes.
• Tightness of all nuts/bolts/castors and other screw in/bolt in/push components.
•
Also check all upholstery (if applicable) for security, splits, exposed staples, etc.
If in any doubt, please do not issue or use, but immediately contact your supplier for service
support.
When reissuing, a risk assessment may be required as to the suitability of the chair for a particular
user.
COMPOSITION
The frame is made from chromium-plated mild steel. You must not, under any circumstances, use any
abrasive cleaners or cleaners which attack chromium plating.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part of or establishing
any contractual or other commitment by Aidapt Bathrooms Limited, Aidapt (Wales) Ltd or its agents or
its subsidiaries and no warranty or representation concerning the information is given.
Please exercise common sense and do not take any unnecessary risks when using this product; as
the user you must accept liability for safety when using the product.
Please do not hesitate to contact the person who issued this product to you or the manufacturer
(detailed below) if you have any queries concerning the assembly/use of your product.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St. Helens, WA9 3EX
Telephone: +44 (0) 1744 745 020 • Fax: +44 (0) 1744 745 001 • Web: www.aidapt.co.uk
Email: accounts@aidapt.co.uk • adaptions@aidapt.co.uk • sales@aidapt.co.uk
COMMODE BUCKET
To remove the commode bucket, simply slide the bucket out from the chrome runners at the rear of
the commode. Cover the top of the bucket to avoid splashing, carefully dispose of the contents into a
proper sluice or WC.
Never use an open drain, sink or basin. This could cause serious health risk.
Clean out the residue with a suitable disinfectant and refit the commode after use.
