Fixing and Maintenance Instructions
Ver.2 08/2012 (2127)
2
INTRODUCTION
Thank you for deciding to purchase the Quick Suction Rail from Aidapt. The Quick Suction
Rail is manufactured from the finest materials and components available. When used
correctly it is designed to give many years of reliable trouble-free service.
NB. This equipment must be installed by a competent person.
Maximum Load 30 kg.
Do not exceed the maximum load; doing so could put the user at risk.
BEFORE USE
•
Carefully remove all packaging. Avoid using any knives or other sharp instruments
as this may damage the surface of the product.
•
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product as it may compromise your safety, but contact your
supplier for support.
INTENDED USE
1.
The Quick Rail is designed to assist your natural motion, as when getting in and out
of a shower. It is not designed to hold or support your full body weight.
2.
The Quick Rail can be used where permanent drilling and fixing is not possible.
3.
Do not attach to moving surfaces.
3.4
The Quick Rail is designed for use only on smooth non-porous surfaces; tile, glass,
porcelain, some plastics.
3.5
Not for use on painted, papered, wood, embossed surfaces.
3.6
Check the condition of the support surface before positioning the Quick Rail.
3.7
Support surfaces should be sound and free from defects.
3.8
Do not mount the Quick Rail where it will be in direct sunlight.
3.9
Check the condition of the suction cups. Do not use if damaged, cracked or split.
3.10
Do not attempt to mount the Quick Rail on mosaic or embossed tiles.
3.11
Check secure attachment before each use.
FITTING
1.
Thoroughly clean the surface with a solvent cleaner or alcohol wipe and allow to
dry.
2.
Raise both levers; place the Quick Rail so that both suction cups lie firmly and
completely on a smooth surface.
3.
Do not place over joints or grout lines.
4.
Press on one lever at one end, then the other. You should feel resistance as the
suction cup tightens.
