4
and the monitor. Doing the latter will help protect
the monitor’s finish.
7.
Hold the monitor up to the mount and align the top
holes. Insert the top screws and finger-tighten until
the mount can take the monitor’s weight.
8.
Let the monitor rest on the mount, and install the
lower screws until tight.
9.
Tighten the upper screws to complete the
installation.
10.
The mount is designed to be re-positioned
repeatedly once the monitor is installed. Do not
attempt to lock the mount arms down so that they
are immobile, as this could damage the mount.
Installation – MT-MWB
2
00
1.
Remove product from packaging. Set hardware kit
aside. The plastic cover over the base of the mount
is removed by pulling it apart from the centerline.
Do not use a tool to pull it apart, as this may
damage the finish.
2.
Hold the mount up to the installation location and
use the flange as a template to mark the top bolt
holes.
3.
Use a level to make sure the mount is vertical
before marking the lower bolt holes. Set the mount
aside.
4.
If drilling into drywall:
a.
Ensure there is a stud where the bolts will go.
b.
Drill pilot holes using a 4mm drill bit to a depth
of 2.3” (60mm).
c.
Hold the mount up to the wall and locate it
over the bolt holes.
d.
Do not use the plastic wall anchors.
e.
Install the #14 screws using a Pozidriv #2
(similar to Phillips) bit or screwdriver.
5.
If drilling into concrete:
a.
Drill pilot holes using a 10mm drill bit to a
depth of 2.5”.
b.
Hold the mount up to the wall and locate it
over the bolt holes.
c.
Insert the plastic wall anchors into the holes.
d.
Install the #14 screws using a Pozidriv #2
(similar to Phillips) bit or screwdriver.
6.
Remove the lower set of fasteners on mount head
(Figure 1, Item 1) and remove the mount head.
7.
Attach this to the monitor using appropriate bolts.
M6 and M8 bolts are provided, but may not work
for every monitor.
8.
Ensure the slotted flange of the mount head is
facing the TOP of the monitor when attaching the
mount head to the monitor.
9.
Hang the Monitor/Mount Head assembly by
aligning the slotted flange with the tongue (Figure
2, Item 1). This will allow the monitor to hang on
the mount while the lower fasteners are re-
attached.
10.
Tilt adjustment bolts are shown in Figure 1, Item 2.
Rotation adjustment bolts are shown in Figure 2,
Item 2.
Figure 1 - Rear of Mount Head
Figure 2 - Detail View
1
2
1
2
100 0301 001 AIG 0
7
/2012
Printed in the U.S.A.
