4
Cleaning
1.Disconnect the appliance from the mains , before cleaning.
2.Do not use solvents or abrasive products to clean the iron , clean with a damp
cloth.
ANTI-DRIP
With the anti-drip system, you can perfectly iron even the most delicate
fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to
the point where no more steam comes out, but rather drops of boiling water
that can leave marks or stains. In these cases, the Anti-drip system
automatically activates to prevent vaporization, so that you can iron the most
delicate fabrics without risk of spoiling or staining them.
Defects and repairs
Do not attempt to replace a defective mains lead .The appliance has to be
returned to an authorized service centre for repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during
manufacture need to be burnt off allow ten minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt , AC electrical outlet only. The
temperature dial must be set at the desired temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to “
0
” and add
water .Allow the iron to heat, and then set the steam dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam
position. Iron should be in the horizontal position. Prime pump briefly. Allow a
short pause between shots. Be sure to fully depress the
burst of steam
button.
Spry mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section
“
how to fill the water tank
”.
Iron is leaking
The variable steam dial must be set on” “,until the iron is hot . The temperature
setting is too low to produce steam. Shot of steam used too much, allow iron to
re-heat.
Warranty: 2 Years
Summary of Contents for 8433325500986
Page 30: ...30 ...
