RACE STUDIO 3 SOFTWARE
44
45
EVO5
CHAPTER 11
11.1.6 Output Signals
11.1.7 CAN Output
Push
"Output Signal"
tab for managing
EVO5 digital outputs.
Here you can define the condition to meet
and the action to perform. In the example
below Channel04 is a temperature channel:
when water temperature is higher than
90°C the digital output will close the circuit
to ground until when the condition is no
longer met.
Push
"CAN Output"
tab do define a CAN Stream Output.
For each payload you can define:
n
ID CAN (Hex)
n
Byte number (DLC): up to 8 bytes
n
Byte Order: little endian or big endian
n
Frequency: up to20 Hz
Moreover you can transmit each field coming from analog, digital, internal channel,
expansions, ECU or GPS Module.
WARNING: Please be advised that this function allows you to send messages directly to
your vehicle CAN network. Sending messages that can potentially conflict with the CAN-
bus frame may cause malfunction of your vehicle's safety systems, resulting in personal
injury or death. It is your responsibility to fully understand your vehicles CAN-bus. AiM
cannot be held responsible for any damage or injury caused by misuse of this function.
