59
22.
CAN Output configuration
You may configure your device to transmit a CAN data stream, both on CAN1 and CAN2, containing the
channels required.
To add a payload:
•
press “+Add new Payload” and “Set CAN Header details” appears.
•
fill in ID CAN (hex), available options are:
o
11 bits (normal address)
o
29 bits (extended address)
•
select the payload max bytes number (DLC), from 1 to 8 bytes
•
select the byte order according to the used processor, available options are:
o
Little endian for Intel compatible processor
o
Big Endian for Motorola processor
•
set the sampling frequency among 1,2, 5, 10 or 20 Hz
When all channels set your configuration is finished:
•
press “Save” on the page top keyboard
•
press “Transmit” to transmit the configuration to
the PDM 32
Summary of Contents for PDM 32
