11
Status of the LED indicator and
Beep
Status of the Tool
Action to be
Taken
LED lights RED, YELLOW, and
GREEN together for one second.
A long beep for one second.
The motor is switched
on.
None required.
The preset torque is not
reached (NOK).
The application
should be re-
worked.
LED lights RED for one second.
A long beep for one second.
The screw has been
refastened after already
tight
-
Double Hit (NOK).
The application
should be
reworked.
LED lights GREEN.
The preset torque is
reached and the tighten-
ing is OK.
None required.
LED Blinks YELLOW five times.
Five short beeps.
Battery power is low.
Recharge battery
or replace with
fully charged
battery.
A long beep for five second.
Battery power is too low
for tool operation and
tool will not run,
Recharge battery
or replace with
fully charged
battery.
LED lights BLUE,
The tool is set to run in
reverse operation,
None required.
LED lights RED twice,
Tool temperature is too
hot. Warning to protect
tool from damage,
Remove battery
and allow tool to
cool.
LED lights RED three times
The motor has a failure,
Send tool in for
service.
LED lights RED four times,
Internal connector wire
has failed.
Send tool in for
service.
TOOL LED INDICATIONS