Declaration of Conformity
CE Conformity Statement
Radio products with the CE alert marking comply with
the R&TTE Directive (1999/5/EC) issued by the
Commission of the European Community. Compliance
with this directive implies conformity to the following
European Norms (in brackets are the equivalent
international standards).
•
EN55032/35 LOW VOLTAGE SWITCHGEAR AND
CONTROLGEAR FOR INDUSTRIAL USE
•
EN300328 v.2.2.2 Technical requirement for
radio equipment
•
EN301893 v2.1.1 WLAN - Spurious Emissions (5G)
•
EN301489-1/-17 EMC radio/WLAN/BT
•
EN50566 RF (SAR)
•
IEC 62368-1 (CB+UL) Product Safety
•
IEC/ EN 60601-1 AMMI/ ANSI ES 60601-1 Medical
Safety
Products that contain the radio transmitter are labeled
with CE alert marking and may also carry the CE logo.
Medical GENERAL EQUIPMENT AS TO ELECTRICAL
SHOCK, FIRE AND MECHANICAL HAZARD
ONLY IN ACCORDANCE WITH ANSI/AAMI ES 6060-1
Europe – EU Declaration of Conformity
This device complies with the essential requirements of
the Radio Equipment directive: 2014 / 53 / EU. The
following test methods have been applied in order to
prove presumption of conformity with the essential
requirements of the Radio Equipment directive: 2014 /
53 / EU:
EN300328 v2.2.2
Draft ETSI EN 301 893 V2.1.0
EN 301 489-1 V2.2.3
EN 301 489-17 V3.2.4
IEC 62368-1:2014
IEC 62368-1:2018
EN 62368-1:2014+A11:2017
EN IEC 62368-1:2020+A11:2020
UL 62368-1, 2nd Edition
UL 62368-1, 3rd Ed
RF exposure statement
SAR
This product complies with EU requirements regarding
restriction of exposure of persons to radio-frequency
energy (RF) emitted by telecommunication and radio
devices as it is designed and manufactured in such a
way as not to exceed the exposure limits indicated by
the European Union Commission. The permitted SAR
limit for the general population is 2.0 W/Kg. This limit
guarantees an ample safety margin that protects all
persons regardless of age and health condition.
5150 ~ 5350 MHz is limited to indoor used in below
countries.
FCC Compliance Statement
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one of the following measures:
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced
radio technician for help.
To assure continued compliance, any changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate this equipment. (Example: use only
shielded interface cables when connecting to computer
or peripheral devices).
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1)
This device may not cause harmful interference,
and
2)
This device must accept any interference
received, including interference that may cause
undesired operation.
15.21
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
authority to operate equipment.
This device and its antenna must not be co-located or
operating in conjunction with any other antenna or
transmitter.
End-users and installers must be provided with antenna
installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
For product available in the USA/Canada market, only
channel 1~11 can be operated. Selection of other
channels is not possible.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment for body-worn configuration in direct
contact to the phantom.
This device complies with FCC radiation exposure limits
set forth for an uncontrolled environment.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End
user must follow the specific operating instructions for
satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction
with any other antenna or transmitter.
The portable device is designed to meet the
requirements for
