GAIA PREAMP DRIVE MK. I
8
DRILL TEMPLATE
Cut out this drill template, fold the edges and tape it to the enclosure. Before drilling, it’s recommended
to first use a center punch for each of the holes to help guide the drill bit.
Ensure that this template is printed at 100% or “Actual Size”. You can double-check this by measuring
the scale on the printed page.
Top jack layout
assumes the use of closed-frame jacks like the
. If you’d rather use
open-frame jacks, please refer to the
Open-Frame Jack Drill Template
for the top side.
LED hole drill size
assumes the use of a
, available from several parts suppliers. Adjust
size accordingly if using something different, such as a 3mm bezel, a plastic bezel, or just a plain LED.
0
1
2
CM
0
1
INCH
ø3/8”
ø1/2”
0.385”
0.625”
0.625”
x: -0.65, y: +1.71
x: +0.65, y: +1.71
ø9/32”
ø9/32”
x: -0.65, y: +0.41
ø9/32”
x: +0.65, y: +0.41
ø9/32”
x: 0, y: -1.775
ø15/32”
x: -0.775, y: -1.775
ø5/16”
CENTER (0,0)
ø3/8”
125B
OUT
BASS
TREBLE
VOLUME
GAIN
FOOTSWITCH
LED
DC
IN
