Using the HYPERPEN:
The HYPERPEN works just like any other pointing device so you can use it to navigate your files and folders in Windows, to surf
the Internet or to drawn lines in any drawing package. You can however change a number of settings in the Control_Panel:
Click Start>Settings>Control_Panel> and locate the HYPERPEN icon as shown on the right.
Double click this Icon and you will see the screen below.
Most of the settings in this utility are self explanatory, such as the ability to
change the measurement units from inches to cm’s. You can also switch
between absolute and relative modes. Absolute mode should allow you to “dot”
an area of the pad and have the cursor jump to the corresponding point on the
screen. If this feature doesn’t work try a different set of drivers from
www.aiptek.com.tw
The Buttons tab allows you to reconfigure your buttons, you can also change
Click Pressure (i.e.. the pressure you have to use on the tablet to simulate a
mouse click) and the Pen Offset. To alter this take the tick out of the Auto
Setting check box and click adjust. The pen will automatically adjust its setting
as you move the pen around the screen.
The Mouse tab allows you to alter the sensitivity and button configuration.
