5. Installation Procedures
air
avionics
Figure 5.4.: Exploded drawing of ATD-57, AT-1, and all small parts of the optional mounting
kit.
Figure 5.5.: Exploded drawing of ATD-57, AT-1, and all small parts of the optional mounting
kit.
1. Prior to installation of the combination of ATD and AT-1, if already installed, please
uninstall the ATD.
2. Install the AT-1 mounting bracket on the ATD. Connect connector 2 of AT-1 to the
lower rear connector (connector 2) of ATD.
3. Use the supplied screws to secure AT-1 on the ATD, install the ATD/AT-1 combination
in the instrument panel using the supplied M3 panel screws.
5.2 Wiring
Wiring depends on many factors such as selected installation options, connected devices,
and aircraft specific requirements.
In most cases, an individual wiring harness is manufactured. We recommend using MIL
34
AT-1
·
Installation Manual
·
rev. 4.0
·
2020/01/09
