air
avionics
5. Installation Procedures
SPEC aviation wire, crimp contacts, and ‘‘Quicklock’’ D-Sub backshells. Wiring diagrams for
most common installation cases are given in appendix D.
In some cases standard accessories may be used. Appendix C shows a list of example
installations using standard accessories as well as recommended configuration parameters
for these installations.
5.3 Antenna Installation
For antenna mounting location considerations, please refer to aircraft manufacturer data
and/or other applicable documentation. Best practices for antenna placement and cable
routing are described in section 4.4.
1. Install all antennas in their positions.
2. Organise and secure all antenna cables.
5.4 Interconnect Installation
1. Install all electrical connectors and ensure that they are appropriately secured.
2. Install the antenna connectors and ensure that they are secured.
3. Optionally, install the static pressure connector and ensure that the tubing connection
is leak-proof.
5.5 Post Installation Configuration, Checkout, and Documentation
A summary of the steps required for checkout, configuration, and installation documentation
is as follows:
•
Perform the installation checks. Instructions can be found in chapter 6.
•
Configure the unit for the specific installation. Work though every configuration item
of the instructions in chapter 7.
•
Perform ground checks. Instructions can be found in chapter 8.
•
Update the aircraft documentation. Instructions can be found in chapter 10.
AT-1
·
Installation Manual
·
rev. 4.0
·
2020/01/09
35
