1. General Description
air
avionics
1.6.3 Non-ETSO Functions
1. Cockpit Display of Traffic Information
2. Cockpit display of traffic-, obstacle-, and general warnings from connected systems.
3. Configuration of connected FLARM compatible systems.
1.6.4 Limitations
The Flight crew is ultimately responsible for traffic avoidance.
This unit shall not be used as the primary means of traffic avoidance and shall be
used for situational awareness only on a no-hazard no-credit basis.
1.6.5 Installation
It is the responsibility of those installing this article either on or within a specific type or
class of aircraft to determine that the aircraft installation conditions are within required
standards. The article may be installed only if performed under applicable airworthiness
requirements. Installation must follow acceptable practices.
1.7 Liability
IN NO EVENT WILL AIR AVIONICS BE LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT OR
CONSEQUENTIAL DAMAGES, WHETHER RESULTING FROM THE USE, MISUSE OR INABILITY
TO USE THE PRODUCT OR FROM DEFECTS IN THE PRODUCT.
1.8 Unpacking and Inspecting Equipment
Before installation into an aircraft, the equipment should be visually inspected for shipping
damages and completeness. If the unit is damaged, notify the carrier. Do not return the
unit to AIR Avionics before the carrier has authorized a claim.
The following parts are normally included with delivery of an ATD:
1.8.1 Air Traffic Display 11 (ATD-11)
Part
Part number
Description
1 x ATD-11 main unit
ATD-11
ATD-11 main unit
4 x screws
–
M2.5 x 4mm screws
1 x connection cable
B394
Standard ATD to RJ45 connection cable
1 x documentation
–
ATD documentation package
8
ATD
·
Installation Manual
·
rev. 3.0
·
2019/05/09
