6
System Configuration
6.1 Configuration Operations
6.1.1 Configuration Menu
ATD-57 is configured in the configuration menu. To enter the configuration menu, push
the inner knob pushbutton for at least 2 seconds (long push). The menu contains several
configuration options and informations about ATD-57 and connected systems.
Please find a menu diagram in appendix B
6.1.2 Configuration Reset to Defaults
In order to reset the system configuration to factory defaults, please perform the following
steps:
1. Disconnect the device from power.
2. Press and hold softkey 3 and softkey 4 while connecting the device to power. Keep
holding the softkeys until the device has booted.
3. All settings are now reset to the factory defaults.
All settings will be reset. This process can not be undone. After factory defaults
have been applied the device is no longer in an airworthy configuration state. All
configuration operations have to be conducted again.
6.2 Device Configuration
In the configuration menu,
DEVICE
contains specific configuration parameters and informa-
tion about the ATD-57 device itself.
6.2.1 Alert Sounder Volume
ATD-57 features an integrated alert sounder (buzzer) for warning annunciation. The alert
sounder volume can be adjusted to meet individual installation requirements. The default
for this value is 3.
To change the alert sounder volume, please carry out the following steps:
1. Open the menu with a long push on the inner knob pushbutton .
2. Use the inner knob to navigate to
DEVICE
→
SOUNDER VOLUME
3. Use the inner knob to select a desired volume.
22
ATD
·
Installation Manual
·
rev. 3.0
·
2019/05/09
