6. System Configuration
air
avionics
Now the brightness level is adjusted using the ambient light sensor in the front bezel of
the device. Restrictions to minimum and maximum brightness levels are configured in
MINIMUM
and
MAXIMUM
.
Brightness Control over Aircraft Lighting Bus
In order to use the aircraft lighting bus, the following configuration actions have to be
taken:
1. change HMI illumination mode
2. configure the input pin used
3. configure input voltage levels
To change the HMI illumination mode to aircraft lighting bus, please carry out the following
steps:
1. Open the menu with a long push on the inner knob pushbutton .
2. Use the inner knob to navigate to
DEVICE
→
INSTALLATION
→
ILLUMINATION
→
MODE
.
3. Use the inner knob to select
LIGHTINGBUS
.
4. Push the inner knob pushbutton to execute your selection.
5. Push the ESC softkey to leave the menu.
To configure the correct input pin for the lighting bus, please carry out the following steps:
1. Open the menu with a long push on the inner knob pushbutton .
2. Use the inner knob to navigate to
DEVICE
→
INSTALLATION
→
ILLUMINATION
→
LIGHTING BUS
→
LIGHT. BUS SRC
.
3. Use the inner knob to select
select the pin, the aircraft lighting bus is connected to
(USENS1 or USENS2)
.
4. Push the inner knob pushbutton to execute your selection.
5. Push the ESC softkey to leave the menu.
Now the brightness level is adjusted using the confirgured lighting bus input pin. To
configure desired voltage levels for minimum and maximum brightness, please carry out
the following steps:
1. Open the menu with a long push on the inner knob pushbutton .
2. Use the inner knob to navigate to
DEVICE
→
INSTALLATION
→
ILLUMINATION
→
LIGHTING BUS
→
LIGHT. BUS MIN
.
3. set the aircraft lighting bus to the minimum level using the lighting bus control in
your aircraft.
4. Push the inner knob pushbutton to execute your selection.
5. Use the inner knob to navigate to
DEVICE
→
INSTALLATION
→
ILLUMINATION
→
LIGHTING BUS
→
LIGHT. BUS MAX
.
24
ATD
·
Installation Manual
·
rev. 3.0
·
2019/05/09
