Air cat 6525-ABS, Operating Instructions, Parts List & Warranty

(in.)

Square 

Drive 

Minute

Max. Torque 

(ft-lb) @90 psi

Weight 

(lbs.)

Length 

(in)

Air Cons. 

(CFM)

Rec. Hose 

Size  

SPECIFICATIONS

Important Warnings - Sanders & Polishers

1.  Eye protection, safety gloves and safety aprons must always we worn when operating a sander or 

polisher.

2.  Never adjust the sander or polisher or change the backing pad, sanding disc, sanding belt or 

polishing bonnet unless the air supply and air hose is disconnected from the tool

3.  Only use backing pads and polishing backing pads that have a rated speed then same as the sander 

or polisher or higher.

4.  Never attempt to modify or adapt a sander or polisher for use with a grinding wheel or cut-off wheel 

or wire brush.

5.  Only personnel trained in the correct methods to change pads, sanding discs, sanding belts and 

polishing bonnets should conduct these operations.

Tools of this class operate on a wide range of air pressure. It is recommended that air pressure of these tools measures 90 PSI at the tool while running free. Higher 
pressure and unclean air will shorten the tool’s life because of faster wear and may create a hazardous condition and void the warranty.  Water in the air line will 
cause damage to the tool. Drain the air tank daily. Clean the air inlet filter screen on at least a weekly schedule. The recommended hookup procedure can be viewed 
in the illustration below.  The air inlet, used for connecting air supply, has standard 1/4” NPT /BSP Thread.  Line pressure should be increased to compensate for 
unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have the same inside dimensions.

Air Supply

Model No. Free Speed 

(RPM)

Motor 

(HP)

Belt Size

(in.)

Weight 

(lbs.)

Length 

(in)

Air Cons. 

(CFM)

Rec. Hose 

Size  

(in.)

Air Inlet 

(in.)

6525-ABS

20,000

0.6

1/4 x 18

Gears

Direct Drive

2.6

15.4

6

3/8

1/4 NPT/BSP