www.airdryclotheslines.com.au
3
Repeat with the opposite post.
Step 4:
Assembling the rear bar
Parts required:
•
2 x Spreaders
•
1 x Joiner
Take 2 spreader bars and insert them into each end of the joiner to make one long bar.
Make sure to leave the ends with the holes outside and facing the same direction.
Step 5:
Assembly
•
2 x Twin fold arm assemblies
•
2 x 750 arms
Place the arm assemblies on the ground with the wall side sticker facing the
ground. Undo the nut at the top of the assembly and thread the 750 arm onto
the bolt. Make sure the arm is facing the same direction as the outer 1500
arm. Secure with the nut. Tighten with the 13mm spanners. Complete this on
both assemblies.
