3/8"-16x4"
Carriage Bolt
Elbow
Air Line
Pal Nut
(flange up)
3/8"
Locknut
3/8" Flat
Washer
3/8"-16x1"
HHCS
3/8"-16x5"
Carriage Bolt
Upper
Bracket
Sleeve
Lower
Bracket
1/2" Flat Washer
1/2" Lock Washer
1/2" HHCS
Box
Clamp
3/8" Flat
Washer
3/8"
Locknut
3/8"
Locknut
Locator
Tab
FORWARD
OUTBOARD
3/8" Flat
Washer
12mm
Hex Nut
BY
MN-299
(03711)
ECN2306
Figure 1
WARNING:
DO NOT INFLATE ASSEMBLY WHEN IT IS NOT RESTRICTED. ASSEMBLY MUST BE RESTRICTED BY
SUSPENSION OR OTHER ADEQUATE STRUCTURE. DO NOT INFLATE BEYOND 100 P.S.I. IMPROPER USE OR OVER
INFLATION MAY CAUSE ASSEMBLY TO BURST CAUSING PROPERTY DAMAGE OR SEVERE PERSONAL INJURY.
INSTALLATION INSTRUCTIONS
P/N 59109
NOTE: It may be necessary to move or
modify the exhaust to install this kit.
NOTE:
There must be no
less than 3.5” from the
bottom of the frame to the
top of axle to install this kit.
This kit WILL NOT FIT if the
frame has been notched.
