WirelessONE
•
Once the receiver has received a message it will sync with that transmitter and stop
clicking the solenoid in 1 second intervals.
HOW TO REMOVE AND INSTALL THE BATTERIES
1. To remove the two CR2032 batteries use a small flat screw driver to seperate the two
halves of the key fob by prying at the internal clip locations shown in fig. 8.
2. Stack the two CR2032 batteries Positive to Negative inside the rear cover.
3. Clip the front cover and circuit board into the rear cover.
FCC INFORMATION TO USER
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THIS
EQUIPMENT.
FCC ID: YHT-BRM920AJM1017
