1 Before use
IP3X
(if serial num-
ber below
MT75-05000)
IP31
(for serial
numbers from
MT75-05000)
Protection Index according to the
EN 60529 standard
3:
protection from the penetration
of solid bodies of diameter ≥ 2.5
mm.
1:
protection against vertically
falling water drops
X:
no particular protection from
the penetration of liquids, but
compliant with EN 60601-1.
This logo means that the equipment
must not be disposed of via ordinary
waste channels. It must receive ap-
propriate end-of-life handling, in ac-
cordance with European Directive
2012/19/UE (WEEE).
This device was manufactured after
the 13th of August 2005.
Electrical protection fuse
COM 1
COM 2
RS232 connectors
Alarm transfer outlet
External power supply connector
AC power supply indicator light
Specific symbols for IRMA™ CO2 measurement probe (ref. KB033600)
IP44
Protection Index
according to the
EN 60529 standard
4:
protection from the penetration
of solid bodies of diameter ≥ 1
mm.
4:
protection from water splash-
ing from any direction
Type BF device
1.6 General safety instructions
Oxygen use
Precautions in case of oxygen leak:
•
No smoking
•
Avoid any flame or source of sparks
•
Disconnect the oxygen source
•
Fully air the room throughout the duration of the leak and for at least 20 minutes afterwards.
•
Air one’s own clothing.
•
The device must not be in operation near any incandescent source.
The device must not be used with inflammable anaesthetic agents or explosive products.
Do not use the equipment with helium or helium mixed with another gas.
11
Summary of Contents for MONNAL T75
Page 2: ......