Air Master AML 100, Operator'S Manual

15

Operation

Inlet Temp.

Inlet temperature in°C.

Outside Temp. Vent.

Outside temperature air 
handling unit in °C.

Room Temperature

Extraction temperature in°C.

Exhaust Temp. Vent.

Exhaust temperature air 
handling unit in °C

Requested Temp.

Setpoint Inlet temperature 
in°C.

Max Room Temp.

Setpoint “High room tem-
perature” in °C.

Pre Heater

Connected in %.

Comfort Heate

r 

Connected in %.

Inlet Damper

Status On/Off.

Ext. Emerg. Stop

Emergency stop function 
status On/Off.

Bypass Damper

Status On/Off.

Bypass Damper

Bypass position in %. (0 = 
closed; 100 = fully open)

Supply Fan

Signal voltage supply fan in 
Volts.

Extraction Fan

Signal voltage extraction fan 
in Volts.

Cooling Module

Operation in %.

Outside Temp.

Outside temperature cooling 
module 
in °C.

Vaporiser temp.

Vaporiser temperature cool-
ing module in °C.

Condenser temp. 

Condenser temperature 
cooling module in °C.

Setpoint Cool. Mod.

Cooling module temperature 
setpoint in °C.

AI#1

0-10V analogue input 1 in 
Volts.

AI#2

0-10V analogue input 2 in 
Volts.

AI#3

0-10V analogue input 3 in 
Volts.

(Text “AI” at inlet #1 - #3 adapted by programming the 
control system.)

Rel. humidity (outside)

  Relative humidity (outside 

air) in %

Rela. humidity (inside)

  Relative humidity (exhaust 

air) in %

Operation

Started By

Operation start signal

- “External”, using external contacts 
and relays.

- “Airlinq”, manual start using a 
control panel.

- “CO2”, using a CO2 sensor.

- “PIR”, using a passive infrared 
sensor.

- “BMS”, using an analogue or digital 
BMS system.

- “Timer”, using a timer.

- “Holiday mode”, via control panel or 
a digital BMS system.

- “Dependent”, on several start 
signals.

Operation State

  Operation status

- “Automatic”, fully automatic opera-
tion according to programming.

- “Manual”, when the automatically 
set air flow or inlet temperature 
is changed by the user or a CTS 
system.

- “Night time cooling” is activated.

- “Holiday mode” is activated.

- “OFF”, the unit is switched off, and 
must be started using the control 
panel.

- “Standby”, the unit is temporarily 
stopped and will start automatically 
according to programming.

System Condition 

Active internal control system 
function

- “Low temperature”.

- “High temperature”.

See “Internal control system functions” on page 25.

NB: If an option is not installed, no operation value 
will show in the status menu.