Air Master AML 100, Operator'S Manual

21

Control and setting

Each group in the system is controlled and set in the same 
way as an individual unit. That means that all control options 
are available for all groups. The status menu and alarm view 
are available for all individual units. A group or single unit 
can be selected for each screen. You can enter or leave the 
menu from all locations.

A “G” or “ID” number is allocated to each group or unit to 
identify which group/unit is being controlled. The G and ID 
numbers can be changed, e.g. to a room name or number 
using Airlinq Service Tool.

Grouping is performed when installing the system using 
Airlinq Service Tool.

4.2.6.1. Select a Group/Unit

The current identification for the group (G) or the unit (ID) 
will be shown at the bottom of the screen. E.g. G8 or ID16

Press “G8”/”ID16”.

>> The selection screen will appear.

This screen shows all groups (G) or units (ID) linked to an 
Airlinq BMS. E.g. G0 to G10 and ID0 to ID16 if the system 
consists of 11 groups with a total of 17 units.

Press the G or ID required. 

>> The screen for that G or ID will be shown.

4.2.6.2. Start, Standby and Switch Off

Start

 or 

restart automatic operation

 for a group/several 

groups

Press the function button.

>> The control menu will appear.

Select the groups to be started and press menu field “

AUTO

”.

>> The group selected will start according to the 
programming.

Start operation manual

.

Press the function button.

>> The control menu will appear.

Select the groups to be started and press menu field “

START

”.

>> The unit will start with standard air flow and 
standard inlet air temperature (see side 18). Text 
“auto” will show with blue light. After 4 hours (time 
can be adjusted to OFF, 0, 1, 2, ... 255 hours using a PC 
with Airlinq Service Tool loaded) or at the next stop 
signal from a timer program, (see side 16) the unit 
will return to automatic operation.

Set a group/several groups in 

Standby

Press the function button.

>> The control menu will appear.

Select the groups to be stopped and press menu field “

STANDBY

”.

>> The groups will stop in 1 hour (time can be adjusted 
to 0, 1, 2, ... 255 hours using a PC with Airlinq Service 
Tool loaded) and then start at the next start signal. 
Otherwise, the groups can be started earlier by using 
the “START” menu field. The air flow indicator will flash 
slowly alongside minimum.

Switch

 off

 a group/several groups

Press the function button.

>> The control menu will appear.

Select the groups to be switched off and press menu field 
“

OFF

”.

Switch

 off system

Press the function button for min. 2 seconds, if the system 
or at least one group is running.

>> All units will switch off. 

GROUPS

ALL

G0

G1