9524 SERIES LOCK
LUBRICATION/SEAL REPLACEMENT
The 9524 Series Lock is lubricated at the factory and should require no
further lubrication. Lubrication is only required when replacing the lock seals.
Extensive testing has shown that the lock seals should last 5 years under normal
operating conditions. Should the seals ever need replacing, a seal replacement
kit is available (AIRTEQ PART NUMBER 400-9524-000).
TO REPLACE LOCK SEALS
1. Remove latchbolt from lock body and remove old piston ring and O-ring .
2. Carefully clean latchbolt and lock body bores with solvent. DO NOT scratch
piston or lock body bores.
3. After parts are clean, lightly lubricate new O-ring with lubricant provided and
install on latchbolt. Install new piston ring on latchbolt.
4. Lightly lubricate the lock body bores with lubricant provided. Carefully insert
latchbolt assembly into lock body. DO NOT tear the O-ring as it enters the bores
or passes by the notch in lock body. DO NOT scratch lock body bores.
5. Reassemble lock and check for proper operation.
NOTE:
Lubricant provided is SYNCO SUPER LUBE WITH TEFLON. Use only
approved lubricant.
9524 Pages 11-19-99
