FLASH BIOS Jumper
FLASH BIOS is an optional feature, contact our sale representatives for
detail.
FLASH BIOS Control
JP12
Disable FLASH (optional) programming.
This is normal operation.
1-2
(Default)
Enable FLASH BIOS programming.
Contents of system board BIOS can be re-
programmed.
2-3
Green PC Jumpers
Pin
JP3
1
Use this pin for controlling general purpose Green
PC device. When signal on this pin goes low, the
external Green PC device connected to this pin
should go into power saving state. The power
management feature must be enabled through
BIOS Power Management Setup.
2
No Connection
Pin
JP39
1
System power down can be invoked by shorting
pin 1 to pin 2 of this jumper. Make sure the BIOS
Power Management Setup options are enabled.
Connect a 2-position switch from the front panel to
this jumper for manual control.
2
Ground
Page 16 486VP System Board User's Manual
Summary of Contents for 486VP
