AIR-I30371A
REV 9/19/18
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are
not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water.
WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
702-461 Airaid SynthaMax Dry Media - Black
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common
non-petroleum all-purpose household cleaner
and water. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner to outside of
air filter and allow to soak. Then flush filter clean
from the inside out with a garden hose and repeat
steps if necessary. Do not apply high pressure
water or air to clean filter. Allow filter to air dry
and reinstall.
Airaid. 1455 Citrus St., P.O. Box 1329, Riverside, CA. 92502 1-800-498-6951 AiraidInfo@airaid.com www.airaid.com
For your Oiled media filter we offer the
Airaid Tune Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
29.
Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!
Continued...
21. Install the provided 90
º
silicone hose onto the
throttle body and secure with the provided hose clamp.
22. Install the provided grommet into the AIRAID
intake tube as shown.
24. Install the 1/4npt vent fitting into the AIRAID intake
tube as shown.
NOTE: Plastic NPT fittings are easy to cross thread.
Install the vent fitting “hand” tight, then turn it two
complete turns with a wrench.
23. Remove the inlet air temperature sensor from the
factory tube and install it into the grommet installed into
the AIRAID intake tube as shown.
NOTE: Take care while installing the inlet air
temperature sensor as it is very fragile.
25. Install the AIRAID intake tube into the silicone
hump hose and then into the silicone hose at the throttle
body. Align the heat shield assembly for proper fit and
then tighten the heat shield mounting bolts then tighten
the hose clamps securing the intake tube.
26. Connect the crank case vent hose to the vent fitting
installed into the AIRAID intake tube. Secure with the
provided tie wrap.
NOTE: Some trimming of the vent hose will be
necessary.
27. Connect the provided inlet temperature sensor
extension into the factory wiring harness and then
connect the other end to the inlet temperature sensor.
NOTE: The vehicle manufacturer uses two different
inlet air temperature sensor connections, choose the
correct extension harness for the sensor provided
by the manufacturer. Secure the harness with the
provided tie wrap.
28. Install the AIRAID air filter and secure with the
provided hose clamp.
