AIR-I40758
REV 11/06/18
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are
not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water.
WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
860-397 Airaid Oiled Media
861-397 Airaid SynthaMax Dry Media - Red
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common
non-petroleum all-purpose household cleaner
and water. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner to outside of
air filter and allow to soak. Then flush filter clean
from the inside out with a garden hose and repeat
steps if necessary. Do not apply high pressure
water or air to clean filter. Allow filter to air dry
and reinstall.
Airaid. 1455 Citrus St., P.O. Box 1329, Riverside, CA. 92502 1-800-498-6951 AiraidInfo@airaid.com www.airaid.com
For your Oiled media filter we offer the
Airaid Tune Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
16.
Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!
Continued...
8. Install the provided coupler hose (08711) onto the
passenger side turbo inlet tube and secure with the
provided hose clamp.
9. Remove the inlet air temperature sensor from the
factory intake tube and remove the O-Ring from the
sensor.
NOTE: The inlet temperature sensor is very fragile,
use caution while handling the sensor.
10. Using the provided grommet, install the factory
inlet temperature sensor into the AIRAID intake tube as
shown.
NOTE: The inlet temperature sensor is very fragile,
use caution while handling the sensor.
11. Install the provided coupler (08760) onto the
AIRAID intake tube as shown and secure with the
provided hose clamp.
12. Install the AIRAID intake tube onto the turbo inlet
tubes and secure with the provided hose clamps.
13. Install the AIRAID air filter into the lower air filter
housing.
14. Reinstall the upper air filter housing onto the lower
housing and into the coupler on the intake tube. Secure
the housing to the lower housing with the factory clips
and to the intake tube with the provided hose clamp.
15. Reconnect the inlet air temperature sensor electrical
connection.
