AIR-I40762A
REV 10/31/18
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are
not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water.
WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
860-397 Airaid Oiled Media
861-397 Airaid SynthaMax Dry Media - Red
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common
non-petroleum all-purpose household cleaner
and water. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner to outside of
air filter and allow to soak. Then flush filter clean
from the inside out with a garden hose and repeat
steps if necessary. Do not apply high pressure
water or air to clean filter. Allow filter to air dry
and reinstall.
Airaid. 1455 Citrus St., P.O. Box 1329, Riverside, CA. 92502 1-800-498-6951 AiraidInfo@airaid.com www.airaid.com
For your Oiled media filter we offer the
Airaid Tune Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
12.
Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!
Continued...
8. Install the two provided quick disconnect vent fittings
into the AIRAID
®
intake tube as shown.
NOTE: Plastic NPT fittings are easy to cross thread.
Install the vent fitting “hand” tight, then turn it two
complete turns with a wrench.
9. Install the provided AIRAID
®
air filter into the lower
air filter housing.
10. Assemble the AIRAID
®
intake tube and upper air
filter housing together loosely, then install the system
onto the throttle body and lower housing. Latch the
upper air filter housing into position and adjust the
intake tube for best fit, then secure with the provided
hose clamps.
11. Connect the two vent lines to the quick disconnect
fittings installed into the intake tube and secure the
EVAP line to the insert on the bottom side of the tube.
