A
irBorne WindSports-
Fun MANUAL – Rev 1
Issue Date: 1 July 2003 Page 21
Section 14 HANG GLIDER COMPLIANCE SCHEDULES
Fun 160
GLIDER MODEL: Fun 160
MANUFACTURED BY: AIRBORNE WINDSPORTS Pty Ltd
NOTE: These specifications are intended only as a guideline for determining whether a given glider is a
certified model and whether it is in the certified configuration.
Be aware, however, that no set of specifications, however detailed, can guarantee the ability to determine
whether a glider is the same model, or is in the same configuration as was certified, or has those
performance, stability, and structural characteristics required by the certification standards. An owner’s
manual is required to be delivered with each HGMA certified glider, and it is required that it contain additional
airworthiness information.
Metric
Imperial
Weight of glider with all essential parts and without cover bags and non essential
parts.
19.0 kg
42 lbs
Leading Edge Dimensions
Nose Plate anchor hole to crossbar plate attachment hole
3130 mm
123.23”
Nose Plate anchor hole to rear sail attachment point
5235 mm
206.10”
Outside diameter at nose
50 mm
1.97”
Outside diameter at cross bar
52 mm
2.05”
Outside diameter at rear sail attachment point
50 mm
1.97”
Crossbar Dimensions
Overall pin to pin length from leading edge attachment point to hinge
bolt at glider centre line
2755 mm
108.46”
Largest outside diameter
62 mm
2.44”
Keel dimensions
1
The cross bar centre load bearing pin
1270 mm
50.00”
The pilot hang loop Fwd
Rear
1475 mm
1525 mm
58.07”
60.04”
Sail Dimensions
Chord length at 3 ft outboard of centre line
2100 mm
82.68”
Chord length at 3 ft inboard of tip
1225 mm
48.23”
Span (extreme tip to tip)
9075 mm
357.28”
Location of Information Placard
Cross Bar
Location of Test Fly Sticker
Front Keel
Recommended Pilot Hook in Weight Range
50-75 kg
110-198 lbs
Minimum Recommended Pilot Proficiency
Novice
Novice
NB: Conversions * 0.4536 kg/pound * 25.4 mm/inch
1
least and greatest allowable distances, whether variable through tuning or through in-flight variable geometry, from the line
joining the leading edge nose bolts to:
Summary of Contents for FUN 160
Page 2: ......
