Turn the cabinet upright and place the
wide end of the float in the circular
area in the bottom of the cabinet. Make sure
the float retainer is between the first and
second bumps on the float. Squeeze the float
retainer’s prongs together, position them
halfway down the long vent slat, then release
the prongs to lock in place.
Slide the wicks into the grooves along the
back of the cabinet. They should nest in
the nodules toward the front of the cabinet.
Remove everything from the cabinet.
Turn the cabinet over and insert the
casters snugly into the bottom. Just use your
hands! Using tools can crack the cabinet.
3
4
2
Place the wick housing on top of the
wicks. Each housing should fit over
two wicks. Make sure that:
•
The wicks align with the grooves on the
front of the wick housing.
•
The hole in the front piece of the wick housing
fits over the nodule between the wicks.
Place the fan assembly on top of the wick
housing.
5
CUTAWAY VIEW
BACK
3
4
FAN ASSEMBLY
WICK HOUSING
Note:
Your Horizon’s wicks and wick housing are pre-positioned
for you. Note this positioning (or take a picture of it) if you decide
to add the casters to your unit, as these will need to be removed
to add the casters.
3
