15
AIRCLEAN
®
SYSTEMS CART ASSEMBLY INSTRUCTIONS
®
®
Model ACA1011 and ACA1039
Your AirClean
®
Systems Cart is shipped with
®
®
the following components:
4 - Cross pieces
8 - 1¼” washers (cross piece washers)
2 - End pieces
4 - 1¾” x ¼” Phillips head bolts (enclosure bolts)
4 - ⅜” washers (enclosure bolt washers)
4 - Casters
8 - 2” x ¼” Phillips head bolts
(cross piece bolts)
ASSEMBLY OF CART
1. Locate a cart end piece and one cart cross piece. Place one ⅜” washer on to a 2”
phillips head bolt.
2. Starting with hole one on the cart end piece place washer and bolt through the hole
and into the threaded receiver of the cart cross piece. Hand-tighten only until cart is
completely assembled.
3. Repeat steps above for holes 2 and 3.
4. For standard setup complete assembly using hole 4. For seated use complete
assembly using hole 5.
5. Tighten all bolts completely.
6. Installation of casters should be per illustration on page 29.
MOUNTING OF ENCLOSURE TO ASSEMBLED CART
1. Place enclosure on assembled cart with front of enclosure and locking casters
on the same side.
2. Locate threaded inserts in base of enclosure. Align inserts with mounting holes
located on the top of the cart end pieces.
3. Place one of the 1¼” washers on each 1¾” Phillips head bolt.
4. Insert bolt and washer into mounting holes on cart and into the threaded receiver in
the base of the enclosure. Hand-tighten only.
5. Repeat this process for all four mounting inserts.
Note: DO NOT OVER-TIGHTEN! Over-tightening will pull
the threaded inserts out of the polypropylene base.
OPTIONS
