AirClean systems POWDERSAFE 760C, Operator'S Manual

7

OPERATING INSTRUCTIONS - POWDERS & PARTICULATE

The following operating instructions are specifi c for containment of powders and particulate.

NOTE:

 Ensure that the INSTALLATION AND ASSEMBLY INSTRUCTION steps

have been completed.

A.  To operate the enclosure:

1.  Before use, ensure that you are not using an incompatible substance within the 

enclosure. With a HEPA fi lter, use only powders

use only powders in the enclosure. For other substances, 

please call our offi ce to verify compatibility before use (in this case, your fi lter may have 

another model number). Direct Dial 919-255-3220 or 800-849-0472. Monday-Friday 

8:00-5:00 PM EST.

2.  Connect the supplied power cord to the unit and to the power outlet. Flip the switch on 

the back of the unit above the power inlet module. This will activate the main power. 

The screen on the controller should light up and display the time and the date. Allow the 

enclosure to run for 5 minutes before beginning your application.

3.  Perform any part of your process that involves powders or particulate inside your 

enclosure.

B.  When working within the enclosure, keep the front sash down and perform your 

      procedure in the center to rear of the enclosure. 
C.  If the low airfl ow alarm sounds and/or lights up, the pre-fi lter or HEPA fi lter may be

     clogged.  
D.  When this happens refer to the “MAINTENANCE” section of this manual.

REMEMBER: 

 Following the instructions assures better protection of the operator

and the environment, and extends the life of the enclosure and fi lter. Correct use

of the enclosure is the responsibility of the operator!

The alarms that are built into the system are maintenance related. They are designed to tell the

operator about conditions that may affect the operation of the enclosure and decrease its

performance.

• ALARM   CHG FILT -

 The change fi lter alarm is a chronological timed alarm that

turns on about two weeks before the HEPA fi lter should be changed. It serves as a

reminder to change the fi lter before it becomes blocked.

• ALARM   FILT BP -

 the BP alarm comes on when either the prefi lter or the HEPA

fi lter becomes dirty and the enclosure requires immediate fi lter maintenance.

• ALARM   LOW AIRFLOW -

 The Low Airfl ow alarm comes on when the face velocity

drops below the pre-set limit.

ALARM MESSAGES