AirClean systems POWDERSAFE 760C, Operator'S Manual

8

OPERATING INSTRUCTIONS - FUMES & VAPORS

The alarms that are built into the system are maintenance related. They are designed to tell the

operator about conditions that may affect the operation of the enclosure and decrease its

performance.

• ALARM   CHG FILT -

 The change fi lter alarm is a chronological timed alarm that

turns on about two weeks before the bonded carbon fi lter should be changed. It serves

as a reminder to change the fi lter before it becomes blocked.

• ALARM   GAS DET -

 The gas detector alarm comes on when breakthrough 

is detected.

• ALARM   LOW AIRFLOW -

 The low airfl ow alarm comes on when the face

velocity drops below the pre-set limit.

ALARM MESSAGES

The following operating instructions are specifi c for containment of fumes and vapors.

NOTE:

 Ensure that the INSTALLATION AND ASSEMBLY INSTRUCTION steps

have been completed.

A.  To operate the enclosure:

1.  Before use, ensure that you are not using an incompatible substance within the 

enclosure.  With a bonded carbon fi lter, use only 

use only liquids

liquids in the enclosure.  For other 

substances, please call our offi ce to verify compatibility before use (in this case, your 

fi lter may have another model number). Direct Dial 919-255-3220 or 800-849-0472. 

Monday-Friday 8:00-5:00 PM EST.

2.  Connect the supplied power cord to the unit and to the power outlet.  Flip the switch on 

the back of the unit above the power inlet module.  This will activate the main power. 

The screen on the controller should light up and display the time and the date.  Allow the 

enclosure to run for 5 minutes before beginning your application.

3.  Perform any part of your process that involves liquids inside your enclosure.

B.  When working within the enclosure, keep the front sash down and perform your 

      procedure in the center to rear of the enclosure. 
C.  If the low airfl ow alarm sounds and/or lights up, the prefi lter or bonded carbon fi lter
      may need to be changed.   
D.  When this happens refer to the “MAINTENANCE” section of this manual.
E.  If the GAS DET alarm sounds, stop your process and call technical support immediately
      at (800)849-0472.

REMEMBER: 

 Following the instructions assures better protection of the operator

and the environment, and extends the life of the enclosure and fi lter. Correct use

of the enclosure is the responsibility of the operator!