地面摇杆操作测试后，进行传感器工作状态测试。
1
拔出飞行模式选择通道
的连接线。
2
将遥控器油门收到最小后打开遥控器开关。
3 X650 Value
接通电源。
4
半蹲姿势，左手抓紧
X650 Value
的底部，举到前上方，高度高于头顶。
5
右手轻推油门至
20%
的杆量。
6
尝试使用左手使飞行器前、后、左、右倾斜，感觉飞行器是否阻止您使飞行器倾斜。
7
如果飞行器没有阻止您使它倾斜，则将油门收到最小，断开
X650 Value
电源，重新检查电路安装（如
AHRS
的安装方向是否正确，连接线
是否接好）后再次测试。
8
如果飞行器的反应正确，将油门推最小，断开
X650 Value
的电源，就可以进行首次试飞了。
（默认为
Input5
）
姿态传感器工作状态测试
AHRS Function Test
After X650 Value stick function test on ground now it goes sensor test.
1 Unplug Flight Mode channel signal cable (default Input 5).
2 Throttle down to lowest then turn on the transmitter.
3 Power on X650 Value.
4 Squat and grasp the bottom side of X650 Value to lift it higher than your head.
5 Apply throttle slowly to 20%.
6 Try to bank the aircraft forwards, backwards, left side and right side and feel it whether aircraft has stopped your moving.
7 If no resistance, throttle down to lowest and power off X650 Value.Check if electronic parts installs properly. (Like AHRS
installation orientation or good connection).Then test again.
8 If aircraft reacts perfect, throttle down to lowest and power off X650 Value.Now you can start your first fly and enjoy it.
测试时请注意安全， 避免被螺旋桨击中。
Pay attention to rotating blades from getting hurt
.
17
www
.
xaircraft.com
