CHEETAH ASSEMBLY INSTRUCTIONS
Parts List:
1 - pair Cheetah tubes
1 - Cheetah Seat
2 - frame bulkheads
2 - 60” frame runner bars
1 - fabric floor
4 - 1’ straps
4 - 3’ straps
4 - web loops
1 - repair kit
1 - owner’s video
1) Slide the frame runner bars into long side loops of fabric floor with the plastic
buckles on the top of floor. The bars will be shorter than the floor.
2) Insert the frame bulkheads into the end of the floor side loops and into the ends of
the runner bars.
3) Wrap the end of the floor under the lower bulkhead bar and clip buckles together
and cinch the web straps to make the floor tight from end to end.
4) Find the position of your CHEETAH seat by sitting in the boat and putting your
feet against the front frame bulkhead.
5) Use the webbing with the sewn loops to secure the Cheetah seat. Loop the web
loops around the runner bars through the floor scups back through the sewn
loops. (the loops are located in the front and the back of the chair). Feed the
webbing through the buckles at the corners of the chair and cinch tight.
6) Inflate the tubes and position the frame such that it aligns with the d-rings.
7) Use the 4 - 1’ straps to tie the exterior frame attachment point to exterior d-rings
on Cheetah tubes.
8) Use the 4 - 3’ straps to cinch to the inside d-rings on the sponson to the upper bar
on the rear and front frame bulkheads.
– 6 –
