erly situated inside of the PVC cover to allow for maximum inflation. Adjust the bow
float bag in the same manner.
PUMA & SUPER PUMA FOAM ASSEMBLY
FOAM INSTALLATION TIP!
Your new foam will be a tight fit in the floor pocket.
Over
time the foam will compress and fit in and out of the pocket with ease. For the first few
times of installation
it will be helpful to start the zippers about 10” from both ends of the
floor pocket before inserting the foam. This will allow for easier closing of the zipper.
Always pull zipper cars in line or parallel to the zipper.
PUMA FOAM ASSEMBLY
Remove the split ring and open the floor pocket. Place the BOTTOM piece into
the pocket by putting one end into place, then arching the piece in the center and
inserting the other end. Press flat. Center the MIDDLE piece over the BOTTOM piece.
Place the TOP piece into the pocket in the same manner as the BOTTOM piece with
the beveled edge up. Pull the sides of the floor pocket up snug, and use your knees
to help squeeze the floor pocket together for zipping. Close the zipper and replace
the split ring. The foam is tight in the floor pocket, as it will compress over time. The
zipper should be closed by hand only.
PUMA FOAM PIECES:
One 18” x 98” x 2” TOP piece
One 21.5” x 55” x 2” MIDDLE piece
One 28” x 110” x 2” BOTTOM piece (tapered at ends)
SUPER PUMA FOAM ASSEMBLY
Remove the split ring and open the floor pocket. Place one of the BOTTOM
pieces into the floor pocket (both pieces are symmetrical). Shove the tapered end of
the remaining bottom piece in the other end of the floor pocket. Lift the wide end of
both bottom pieces up until the two ends align, then push down to get the foam to lay
flat in the pocket. Center the MIDDLE piece over the BOTTOM pieces. Place the TOP
piece into the pocket by putting one end into place, then arching the piece in the
center and inserting the other end. Press flat. Pull the sides of the floor pocket up
snug, and use your knees to help squeeze the floor pocket together for zipping.
Close the zipper and replace the split ring. The foam is tight in the floor pocket, as it
will compress over time. The zipper should be closed by hand only.
– 9 –
