12
INSTALLING THE LIGHT BULBS & GLASS SHADE
WARNING:
Shut off the power supply before removing or replacing lamp. In handling of halogen bulb, care should be
taken not to touch it with your bare hands. Oil residue will shorten the life of the halogen bulb. If you accidentally come
into contact, wipe thoroughly with a clean, lint-free, cotton cloth. Allow the bulb to cool for 10 minutes before changing
the bulb. Use light bulb in accordance with the fan's specification. DO NOT EXCEED THE MAXIMUM WATTAGE RATING.
ATTENTION:
The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping
exceeds 190 watts, the ceiling fan's light kit will shut off automatically.
1. Install 2 x 50W halogen bulbs (included). (Fig. 18)
2. Remove the decorative cap from the light kit. Raise the glass shade up against the light kit, secure with the decorative
cap. Do not over tighten. (Fig. 18)
FIG. 18
LIGHT KIT
GLASS
SHADE
DECORATIVE CAP
50 W HALOGEN
BULBS
