OPERATING THE FAN
Check the fan before switching it on!
Risk of injury:
The fan can only be operated if no defects have been found upon inspection.
In case a part is defective, it will have to be replaced before using the fan.
Risk of injury:
Before changing the fan rotating direction, the fan has to be switched off and come
to a complete stop.
Check that the fan is in safe operating condition:
-
Check to make sure that there are no visible defects.
-
Verify that all parts are properly installed and fastened.
Remote control
Install one 12 volt battery (type 23AE, not included)
to the remote control.
Buttons:
1
- Fan speed control: controls the ceiling fan speed
(I for the lowest speed, VI for the fastest speed)
2
- Fan OFF: turns the fan off
3
- Reverse function: controls fan direction
4
- Lighting control: adjusts the intensity of the light (if
applicable, depending on bulb).
5
- CODE setting: using method as below
Step 1: Finish the installation of the ceiling fan.
Step 2: Turn the power on for the ceiling fan and
within 60 seconds, press and hold SET button on
back of remote control for 5 seconds. The light of the ceiling fan flashes twice when setup is completed.
Step 3: After setup is completed, switch to the desired speed. The fan will run on the highest and lowest
speed first, and will then turn to the selected speed automatically.
6
- Light setting: selects On/Off or Dimming function for light
<D> On/Off function without dimming (required for energy saving lamps [CFL]).
<ON> Dimming function enabled (for tungsten lamps; not compatible with energy saving lamps [CFL]).
Note: After changing the blades, the CODE setting has to be performed again.
Note: The receiver provides protection in the following two situations:
1- Lock protection: The receiver has a built-in protection against obstruction during operation. The
motor will be locked and the power will be disconnected after 30 seconds of obstruction. Please
remove obstacles before restarting. To reset, turn off the power supply to the fan motor, then restart.
2- Power surge protection: If the receiver detects a power consumption of the motor greater than 80W,
the power supply will be interrupted and operation will immediately stop. To reset, turn off the power
supply to the fan motor, then restart (after 5 seconds).
CLEANING
Risk of injury:
Before cleaning the fan, always switch off the power at the main circuit breaker and
wait until the fan has come to a complete stop.
Clean the fan with a dry or damp soft cloth. Do not use any liquids or detergents.
